Upgrade Drive

Figure 1. Mounting holes (backside view)
These holes are used for the upgrade.

Figure 2. Mounting holes (front side view)
Cut out suede hole covering, with a sharp knife

Figure 3. Mounting holes are now ready for gearbox insertion

Figure 4. Plug the gearbox motor lead and connector into the circuit board as shown (J3 position)

Figure 5. Now the gearbox/motor assembly is ready for installation

Figure 6. Insert gearbox in position as shown and hold in place

Figure 7. Secure the gearbox in position using the supplied truss head screws with a
Phillips head screwdriver

“Congratulations”

Your triple “upgrade” is now installed and ready to go.

Questions / Problems? Call us @ 1-800-800-4436

Orbita Corporation

Wilmington N.C